General:
Trace and cut out patterns. Follow directions on patterns.
Click here for the
patterns in PDF format.
Click here for the
patterns in JPG format.
Penguin:
From black felt cut 3/8" x 10¼" strip. Glue strip around edge of lip. Glue
head on top of lid. See photo. Glue face on head so bottom of face is even
with bottom of head. Glue eyes on face. Hold beak where indicated by dash
line on pattern. Glue bottom of beak on face below eyes. For cheeks, use
cotton swab to apply blush on face. For earmuff band, twist red, green, and
white chenille stems together. Cut band to measure 7"; discard remaining
length. Glue band along side edges of lid. For muffs, glue one pom-pom on
each end of band. Tie ribbon into a 2¼" wide bow; cut ribbon ends in a "V".
Glue bow on center bottom of face. For hanging loop, cut a 10" length from
nylon thread. Thread one end of nylon thread between earmuff band and top
edge of head; knot ends. Apply dot of glue on knot to secure. Let dry.
Reindeer:
From brown felt cut a 3/8" x 10½" strip. Glue strip around edge of lip. Glue
head on top of lid. See photo. Glue antlers on top of head. Glue two ears
together for one ear. Repeat same for remaining ears. Glue ears on head
below antlers. Glue muzzle on head so bottom of muzzle is ½" from bottom of
head. For nose, center and glue pom-pom to top of muzzle. Glue eyes on head.
Tie red gingham ribbon into a 3" wide bow; cut ribbon ends in a "V". Glue
bow on center bottom of head. Sew jingle bell to bottom of bow know.
(Optional: Glue bell to bottom of bow knot.) For hanging loop, glue ends of
green ribbon together on back center top of lid. Let dry.
Snowman:
From white felt cut a 3/8" x 10½" strip. Glue strip around edge of lip. Glue
head on top of lid. See photo. Glue hat on top of head. For hat band, glue
green and red striped ribbon on hat as shown. Glue snowflake on hat band at
right edge of hat. For eyes, glue black buttons on head. Glue nose on head.
Separate snaps. (Note: Save top of snap for another project or discard.)
Glue bottom of snaps on head for mouth. Tie red plaid ribbon into a 3" wide
bow; cut ribbon ends in a "V". Glue bow on center bottom of head. Glue green
button on center of bow. For hanging loop, glue ends of rickrack together on
back center top of lid. Let dry.
Gingerbread:
From tan felt cut a 3/8"
x 10½" strip. Glue strip around edge of lip. See photo. Use pencil to draw a
smile on one side of head where indicated by dashed line. Using 6 strands of
floss, sew mouth on head in a backstitch. (Optional: Use marker to draw
smile.) Glue head on top of lid. For eyes, glue buttons on head. Glue cheeks
to each corner of mouth. Glue pom-pom nose to center of head. Glue rickrack
around top edge of head. Tie stripped ribbon into a 2½" wide bow; cut ribbon
ends in a "V". Glue bow on center bottom of head. For hanging loop, glue
ends of green ribbon together on back center top of lid. Let dry.
|